Demo for Swarm into filters
Posted: Tue Feb 06, 2018 4:43 pm
First requirement is simply normal, typical, filtering. The Swarm demo video uses no filter and the output is far too noisy.
Second, there are complaints that the treble turns to white noise with high swarm counts. One solution to demonstrate would be to have, say, TWO swarms. The first would have large detune but go through a filter with cutoff say 1000Hz. The second would have a much smaller detune and go through a HPF again at 1000Hz. This would allow you to have low frequencies as detuned as you want, but have the high frequencies more focused.
Heck, you could make the high part a single sawtooth if you wanted, or a far smaller number of sawtooths, etc.
Second, there are complaints that the treble turns to white noise with high swarm counts. One solution to demonstrate would be to have, say, TWO swarms. The first would have large detune but go through a filter with cutoff say 1000Hz. The second would have a much smaller detune and go through a HPF again at 1000Hz. This would allow you to have low frequencies as detuned as you want, but have the high frequencies more focused.
Heck, you could make the high part a single sawtooth if you wanted, or a far smaller number of sawtooths, etc.